Cove Red Sandstone

Technical Data Sheet
Cove Red Sandstone
Cove Quarry, near Kirk Patrick Fleming, Scotland
Bolehill Quarry, Wingerworth, Derbyshire, S42 6RG
Contact : Blockstone Ltd
Tel: 01246 554440 Fax: 01246 220095
Email: [email protected]
Website : http://www.realstone.co.uk/blockstone
Grid reference : —- —-
Compiled November 1997, updated June 2000

This data sheet was compiled by the Building Research Establishment (BRE)., The data sheet was compiled in November 1997 and updated in June 2000 using BRE test results and data collected in earlier surveys. The work was carried out by BRE as part of a Partners in Technology Programme funded by the Department of the Environment, Transport and the Regions and Blockstone Ltd and does not represent an endorsement of the stone by BRE.

General
The quarry is near Kirk Patrick Fleming, near Annan in Dumfries and Galloway. It was open in the 19th century and records show that it has been used for buildings since at least 1890.

Petrography
Cove Red Sandstone is a sandstone is from the New Red Sandstone of Triassic age. It is a fine-grained stone, red/brown in colour with varying bed definitions. The average block size is 2000mm x 1000mm x 400mm.

Expected Durability and Performance
It is important that the results from the individual tests are not viewed in isolation. They should be considered together and compared to the performance of the stone in existing buildings and other uses. Sandstones from the New Red Sandstone are traditionally acknowledged as generally being a very durable building stone and have been used extensively in many towns and cities in the UK. Cove Red Sandstone appears to be a durable stone that is not effected by acid rain or air pollution. Most sandstones have good frost resistance. The failure in the harsh saturated sodium sulphate crystallisation test indicates susceptibility to salt damage (for example in coastal locations or from de-icing salts). The compressive strength of the stone is towards the lower end of the range for sandstones but is comparable with that for UK limestones.

Overall, Cove should be suitable for use in most aspects of load bearing masonry and cladding but should not be used in areas where a long service life is needed in locations with a high salt concentrations.

Test Results – Cove Red

Safety
in Use
Slip Resistance (Note 1)

Not determined

Values > 40 are considered
safe. 
Abrasion Resistance
(Note 1)

Not determined

Values <23.0 are considered
suitable for use in heavily trafficked
areas
Strength
under load
1) Compression(Note 2)

116.11 MPa

Loaded perpendicular to the
bedding plane ambient humidity
Compression (earlier data)

41 – 56 MPa

Dry. Loaded perpendicular to the
bedding 

27 – 33 MPa

wet. Loaded
perpendicular to the
bedding 

24 – 37 MPa

Dry. Loaded parallel to the
bedding 

11 – 25 MPa

Wet. Loaded parallel to the
bedding 
2) Bending (Note 1)

8.52 MPa

Loaded perpendicular to the
bedding plane
ambient humidity

4.53 MPa

Loaded parallel to the
bedding plane
ambient humidity
Porosity
and Water Absorption
1) Porosity (Note 3)

15.8%

23.4 – 25.4%%

(based on earlier
data)
2) Saturation Coefficient (Note 3)

0.61

3) Water Absorption

4.33 % (by wt)

4) Bulk specific gravity

2243kg/m3

1970-2030kg/m3

(Based on earlier data)
Resistance to Frost 
  Freeze/Thaw Test (Note 1)

Not determined

Resistance
to Salt
Sodium Sulphate Crystallisation Test
(Note 3)

-0.29% Mean wt loss

Resistance to Acidity 
Acid Immersion Test(Note 4)

Pass 

(Test methods Note 1 = EN1341, Note 2 = EN 1342, Note 3 = EN 1341 /BRE 141, Note 4 = BRE 141)

Tests were carried out at BRE in 1997. N.D. = not determined

Return to Stones Glossary